Air hockey flock for 4 inch (104mm) mallet

Looking to minimise the marks and scratches to you air hockey table surface? Then these self-adhesive air hockey mallet flock rings are just what you are looking for.

Made from quality flock (felt like) material with a self-adhesive backing, these air hockey mallet flock rings are easy to apply and easy to replace.

For best adhesion remove the shine or any previous adhesive from the base of the air hockey mallet where the flock is to be placed with fine sandpaper. Wash the base thoroughly with warm soapy water (or mentholated spirits) to remove any dust, grease or impurities that may affect the flock adhesion. Allow to dry completely prior applying the flock. Remove the flock paper backing and position in the center of the base of your air hockey mallet and press firmly in place, then press firmly around both the inside and outside edges of the flock.

Why does air hockey mallet flock have a hole in the middle?
This is to eliminate any air being trapped between the mallet and the flock which may cause the adhesive to fail or the flock to bubble or crease, and you to ensure you get full contact adhesion on the inner edges of the air hockey mallet flock.