Foosball table plastic rool bearings

The foosball table player rod rool bearings, sometimes called player rod bushes, are placed in the side of the foosball table to provide support and a smooth rotating surface for the player rods. The rool bearing assembly consists of two parts; a male part (placed on the outside of the table sides) and a female part (placed on the inside of the table side).

The rool bearing assembly screws together between the foosball table sides giving a neat and tidy finish, and can accommodate up to 38mm wide side panels. The outside flange also has 3 x screw dimples allowing you to drill out the dimples and fix the rool bearing in place using small wood screws for additional support. This is also an ideal way to fix the rool bearings on foosball tables with side panels greater than 38mm.

The rool bearings flange is 50mm (2 inches) in diameter and a 25mm mounting hole is required to fit the rool bearing.

TIP: The rool bearings need to be fairly tight fitting, if the 25mm hole isn't quite large enough to accommodate the rool bearing a little sanding to enlarge the mounting hole slightly may be required.

Please Note: The rool bearings are all black, not black and white as shown in the picture.